Raised embroidery

In addition to normal satin stitching, the software also provides raised or '3D' satin, both for outlines and fills. The resulting embroidery consists of multiple layers of satin stitching which adds dimension and a raised tactile surface to your designs. Of course it also uses a lot more stitches.

There are a number of techniques for creating trapunto designs. Traditional hand-trapunto involves sewing two layers of fabric together with a motif outline. The underside is then slit and stuffed with yarn or cotton. Another technique is to use 3D Satin instead of stuffing or batting in order to create dimension.

On this page...


Use Object Properties > Line > 3D Satin to create raised satin borders – can be used with trapunto for quilting effects.

Use Object Properties > Fill > 3D Satin to create raised surfaces – can be applied to lettering or used with trapunto for quilting effects.

3D satin

Typically, 3D Satin is used to create extra body in satin objects for visual effect and to provide a raised or 'sculpted' surface.  Recommended settings for best loft are 0.30mm manual for satin spacing with 4 layers.


Use Advanced Digitize > Create Trapunto Outlines to force travel runs to the edges of selected objects. Typically used with open stitching and no underlay.

Quilting with trapunto outlines

Traditionally, quilted embroidery creates dimension by stuffing or filling areas to produce a raised surface. It employs a technique known as ‘trapunto’, also referred to as ‘stuffed embroidery’. A similar effect can be achieved using two software tools:

  • 3D Satin: This allows you to create ‘puffy embroidery’ as an alternative to stuffing with yarn or batting.
  • Trapunto outlines: The trapunto component allows you to stitch layers of fabric over top.

The Create Trapunto Outlines feature is used exclusively with 3D Satin to create a ‘quilted’ look. When activated, this feature always defaults to the next unused color so as to force the machine to stop before trapunto outlines are stitched. This allows you to place the covering fabric. The process is as follows...

  • Digitize the design using 3D Satin and select all objects you want to include.
  • Use the Create Trapunto Outline tool to create trapunto outlines. Preset color, offset, and outline type as preferred.

  • Stitch the design on a backing fabric or heavy cutaway stabilizer.
  • Next, cover the design with the main fabric and stitch the trapunto outline.
  • Trim the stabilizer or backing close to the design stitching on the back.